Site Logo
Site Logo
 
It is currently Sun Feb 19, 2017 4:26 pm

All times are UTC




Forum locked This topic is locked, you cannot edit posts or make further replies.  [ 4 posts ] 
Author Message
 Post subject: Post Processor to Fanuc 21i MB
PostPosted: Thu Jul 07, 2016 1:46 pm 
Offline

Joined: Thu Jul 07, 2016 1:25 pm
Posts: 3
I'm evaluating FeatureCam but when I want to generate the CN code to my machine, this doenst have the postprocessor to FANUC 21i MB...where I can find it?


Top
 Profile  
 
 Post subject: Re: Post Processor to Fanuc 21i MB
PostPosted: Fri Jul 08, 2016 7:39 pm 
Offline

Joined: Sat Mar 10, 2007 6:23 am
Posts: 270
Location: S.F. Bay Area
Look for a folder named "Post", and the following sub-folders: Mill, 3-axis, Fanuc (should be in the location where you installed FeatureCAM). There is a 21M, 0M, 6M and Robodrill post.
Any of these posts should work pretty much the same but be carefull, depending on the settings and parameters of your specific machine these posts may need some "tweaking" before they are completely safe to run!!!
Good Luck :D


Top
 Profile  
 
 Post subject: Re: Post Processor to Fanuc 21i MB
PostPosted: Fri Jul 08, 2016 9:41 pm 
Offline

Joined: Thu Jul 07, 2016 1:25 pm
Posts: 3
I have tried with it, but doesn't work....thanks for your support


Top
 Profile  
 
 Post subject: Re: Post Processor to Fanuc 21i MB
PostPosted: Sun Jul 10, 2016 4:25 pm 
Offline

Joined: Thu Jul 07, 2016 1:25 pm
Posts: 3
Thanks for u contribution, I have tried with it, but it doesnt work....
U say that I can do some tweaking in these posts ....do u now where I can find information how can I do that

thank you


Top
 Profile  
 
Display posts from previous:  Sort by  
Forum locked This topic is locked, you cannot edit posts or make further replies.  [ 4 posts ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB